Goulds Pumps XHD - IOM - Manual (Page 30)

Installation
Refer to pump general arrangement drawing for center distance ranges.
Figure 7: V-belt tension
Many v-belt drive manufacturers offer tension measurement tools that can aid in setting
proper belt tension. Contact the v-belt drive manufacturer for more information.
3. Secure the overhead motor mount on slide base in place once the belts are properly
tensioned.
4. Install the unit after installation to ensure that the belts and sheaves do not come into
contact with the guard.
CAUTION:
The unit must not be operated without the proper drive guard in place. Operating the unit without the
drive guard in place could result in personal injury to operating personnel.
Install the pump, driver, and coupling
1. Mount and fasten the pump on the baseplate. Use applicable bolts.
2. Mount the driver on the baseplate. Use applicable bolts and hand tighten.
3. Install the coupling.
See the installation instructions from the coupling manufacturer.
Pump-to-driver alignment
Precautions
WARNING:
• Follow shaft alignment procedures in order to prevent catastrophic failure of drive components or
unintended contact of rotating parts. Follow the coupling installation and operation procedures from
the coupling manufacturer.
• Always disconnect and lock out power to the driver before you perform any installation or
maintenance tasks. Failure to disconnect and lock out driver power will result in serious physical
injury.
NOTICE:Proper alignment is the responsibility of the installer and the user of the unit. Check
the pump-to-driver alignment before you operate the unit. Failure to do so can result in
equipment damage or decreased performance.
NOTICE:
Proper alignment is the responsibility of the installer and the user of the unit. Check the
alignment of frame-mounted units before you operate the unit. Failure to do so can result in
equipment damage or decreased performance.
28 XHD Installation, Operation, and Maintenance Manual