ATEN NETTM SN0108 - Manual (Page 100)

SN0108 / SN0116 User Manual
90
4. Select either Obtain an IP address automatically (DHCP), or Specify an
IP address. If you chose the latter, fill the IP Address, Subnet Mask, and
Gateway fields with the information appropriate to your network.
5. Click Set IP.
6. After the IP address shows up in the Device List, click Exit to end the
program.
Method 2:
1. Set your computer's IP address to 192.168.0.XXX
Where XXX represents any number or numbers except 10. (192.168.0.10 is
the default address of the SN0108 / SN0116.)
2. Specify the switch's default IP address (192.168.0.10) in your browser, and
you will be able to connect.
3. Assign a fixed IP address for the SN0108 / SN0116 that is suitable for the
network segment that it resides on.
4. After you log out, be sure to reset your computer's IP address to its original
value.
Method 3:
A fixed IP address can also be assigned with the ARP command as follows:
1. Turn off the power to the SN0108 / SN0116.
2. Enter the following command:
arp -s <ip address> <SN0108 / SN0116's MAC address>
Where the IP address that you assign is one suitable for the network
segment that the SN0108 / SN0116 resides on.
Note: The SN0108 / SN0116's MAC address can be found on its bottom
panel.
3. Turn the power to the SN0108 / SN0116 back on.
sn816.book Page 90 Thursday, December 13, 2007 5:16 PM