ATEN NETTM SN0108 - Manual (Page 23)

Chapter 2. Hardware Setup
13
SN0108D / SN0116D PC Installation
Refer to the Installation Diagram on page 14 (the numbers in the diagram
correspond to the numbers of the steps), as you do the following:
1. For each server or serial device, plug an RJ45 to Serial adapter into its
serial port. (See RJ-45 to Serial Adapters, page 92, for details on choosing
the appropriate adapter.)
Note: RJ-45 to Serial adapters require a separate purchase. To purchase
RJ-45 to Serial adapters, contact your dealer.
2. Use standard Ethernet cable to connect any available port on the SN0108D
/ SN0116D's rear panel to the adapter.
3. If you choose to install a serial modem for OOB operation (see Chapter 6),
use standard Ethernet cable to connect any available port on the SN0108D
/ SN0116D's rear panel to a DTE to DCE serial adapter (see RJ-45 to
Serial Adapters, page 92 for details on choosing the appropriate adapter),
then plug the adapter into the modem's serial port.
Note: This step is optional.
4. Plug the cable that connects the SN0108D / SN0116D to the network or
the Internet into its LAN port.
5. Connect the DC power source to the switch (refer to the installation
diagram for details).
6. Ground the switch.
This completes the SN0108D / SN0116D installation.
sn816.book Page 13 Thursday, December 13, 2007 5:16 PM