ATEN NETTM SN0108 - Manual (Page 89)

Chapter 7. Real COM Port Management
79
3. Click OK to complete the operation.
Note: 1. If a range of ports was selected, and Map consecutively is enabled, the
COM ports are mapped to the Target ports in sequence based on the
port numbers.
2. Only Virtual Mode ports are mapped. Other ports in the range are
passed over.
Port Unmapping
To unmap virtual COM ports:
1. Either click Unmap… on the button bar or select Unmap… from the menu
to bring up the Port Unmapping dialog box:
2. Drop down the list of mapped COM ports and select the COM port you
wish to unmap.
3. Click OK to complete the operation.
Note: For a consecutive unmapping, the COM ports are unmapped in
sequence based on the mapped COM port number.
sn816.book Page 79 Thursday, December 13, 2007 5:16 PM