SawStop CNS175-AU - Manual (Page 25)

SawStop 10” Contractor Saw 23
Assembling
Your Saw
18. Align the four holes in the belt guard with the four
screws on the pulley side of the motor. Use four M5
washers and four M5 hex nuts from the hardware
pack to mount the belt guard to the pulley side of the
motor (see Fig. 18). Use an 8 mm socket to tighten
the hex nuts.
Assembling Your Saw
Installing the Motor and Belt Guard
17. Locate the motor, the motor belt, the belt guard, and hardware pack #2. All of the hardware needed to install the
motor and belt guard is located in the area with the green background on hardware pack #2. Attach the motor
to the saw by sliding the motor mounting pins into the corresponding holes in the rear trunnion (see Fig. 17).
Make sure the pins slide all the way into the holes. Use the 3 mm hex key included with hardware pack #2 to
tighten the two lock down set screws to hold the motor in place.
Tools
Hex Key, M3 (1)
Hex Key, M5 (1)
Hex Key, M8
(1)
Mounting the Switch Box
Hardware for Step 22
Switch Box Keys (2) Washers, M6 (2) 14 Hex Screws, M6 x 20 (2) 15
Installing the Motor and Belt Guard
Hardware for Steps 17-19
Washers, M5 (4) 10 Hex Nuts, M5 (4) 11
Mounting the Extension Wings
Hardware for Steps 20-21
Lock Washers, M8 (8) 12 Hex Screws, M8 x 16 (8) 13
Hardware Pack # 2
Blade Spacing Adjustment Gauge (1)
Fig. 17
Fig. 18
lock down
set screws
mounting
pins
Made in Taiwan SawStop, LLC www.sawstop.com TCP
actor Saw
Model No. CNS 175 Serial No. C074012345
Electrical / Electricidad / Électricité
115/230 Volts, 60 Hz 15/7.5 Amps 1 Phase
1.75 HP 3450 RPM
® c US 175370
11
10
rear trunnion