SawStop CNS175-AU - Manual (Page 27)

SawStop 10” Contractor Saw 25
Assembling
Your Saw
Mounting the Switch Box
22. The hardware required to mount the switch box to
the cast iron table top is located in the area with the
orange background on hardware pack #2. Use two
M6 washers and two M6 x 20 hex screws to mount
the switch box under the left extension wing (see
Fig. 22). Tighten the screws with a 10 mm wrench.
Congratulations, your saw is now assembled.
Tools
Hex Key, M3 (1)
Hex Key, M5 (1)
Hex Key, M8 (1)
Mounting the Switch Box
Hardware for Step 22
Switch Box Keys (2) Washers, M6 (2) 14 Hex Screws, M6 x 20 (2) 15
Installing the Motor and Belt Guard
Hardware for Steps 17-19
Washers, M5 (4) 10 Hex Nuts, M5 (4) 11
Mounting the Extension Wings
Hardware for Steps 20-21
Lock Washers, M8 (8) 12 Hex Screws, M8 x 16 (8) 13
Hardware Pack # 2
Blade Spacing Adjustment Gauge (1)
Note: You must install a rip fence prior to using the saw. Refer to the manual
accompanying your rip fence for instructions on how to install the fence.
Assembling Your Saw
15
14
SawStop
System Status Cod es
Status Red Grn
¯ ¯ ¯
Wet Wood Overload Due To
During Bypass Contact Detect ed
During Standby Contact Detect ed
Brake Adjust Position of
Doors Close Access
Key To “On” Turn Cartridge To “Off” Turn Start Swit ch
Bypass Mode On
Coasting Down
Replace Cartridge System Ready
System Initializing
• • • • • •
¯ ¯ ¯
¯ ¯ ¯
• • • • • •
¯ ¯ ¯ • • • • • •
• • • • • • • • • • • •
• • • • • •
¯ ¯ ¯ • • • • • •
21. Use a straight-edge to level the extension
wings with the cast iron table top and tighten
all of the M8 x 16 hex screws with a 13 mm
wrench (see Fig. 21).
Fig. 21
0 15 30
45
SawStop
10” Contractor Saw
Fig. 22