Muxlab Passive CCTV/GLI Hub - Manual (Page 10)

© MuxLab Inc. Passive CCTV/GLI Hub Installation Guide
Page 10
Port Switch Settings:
4. For each camera port, determine whether video,
power and/or control is to be transmitted via the
same Cat5 cable. If only video is to be transmitted,
then the Power/Control terminals and port switch
may be disregarded.
5. In order to transmit video on one (1) twisted pair,
remote power on two (2) twisted pairs and control on
one (1) twisted pair, set the port switch to Pass-Thru
Mode (500022) using a small flathead screwdriver,
as shown in fig 6. Ensure that there is a CCTV Pass-
Thru Balun (500022) at the camera.
Figure 5: Port Setting – Pass-Thru Mode (500022)
6. In order to transmit video on one (1) twisted pair and
remote power on three (3) twisted pairs, set the port
switch to Power-Thru Mode (500024/500029) using
a small flathead screwdriver (fig 7). Ensure that there
is a CCTV Power-Thru Balun (500024 or 500029) at
the camera.