Muxlab Passive CCTV/GLI Hub - Manual (Page 12)

© MuxLab Inc. Passive CCTV/GLI Hub Installation Guide
Page 12
Output Connections:
Video:
7. Connect one coax cable between each video output
port on the rack and the DVR video input (fig 8).
Figure 7: Video connection
Remote Power:
8. If remote power is being transmitted to the camera,
verify that the distance between the camera and the
hub is within MuxLab specifications. Please consult
the distance charts at the back of the installation
guide. When the port switch is set to Pass-Thru
Mode (500022), two (2) twisted pairs are used for
remote power. When the port switch is set to Power-
Thru Mode (500024/500029), three (3) twisted pairs
are used for remote power thus supporting greater
distance.