Kramer Electronics RB-6 - Manual (Page 11)

RB-6 - Defining the RB-6 6 Channel Power Controller 7
7
The following table refers to both Figure 1 and Figure 2 .
# Feature Function
1 IR Receiver Infrared remote control sensor
2 IR LED Lights yellow when receiving commands from the IR remote control
transmitter
3 POWER LED Lights green when the device is powered on
4 ACTIVE OUTPUTS
Buttons (1 to 4) Press a button to turn on the output. The relevant button LED lights
red.
Press the button again to turn the output off. The button LED no
longer lights
5
ACTIVE
OUTPUTS 5
Controls
MAX Press to set the output voltage to maximum. Press and hold to set
the current setting as the maximum voltage
MIN Press to set the output voltage to minimum. Press and hold to set
the current setting as the minimum voltage
Rotary
control Turn clockwise to increase or anti-clockwise to decrease the output
voltage
6
ACTIVE
OUTPUTS 6
Controls
MAX Press to set the output voltage to maximum. Press and hold to set
the current setting as the maximum voltage
MIN Press to set the output voltage to minimum. Press and hold to set
the current setting as the minimum voltage
Rotary
control Turn clockwise to increase or anti-clockwise to decrease the output
voltage
7 PROGRAM Switch For the use of Kramer service personnel only
8 RS-232 9-pin D-sub
Connector (F) Connect to an RS-232 controller, such as a PC (see Section 6.3 )
9 REMOTE IR 3.5mm
Opening For installing the optional external IR receiver 3.5mm mini jack (see
Section 3.1 )
10 ETHERNET RJ-45
Connector Connect to a remote PC controller over a LAN (see Section 6.2 )
11 OUT 1~4 Power Sockets Plug in devices to be controlled only on and off
12 OUT 5~6 Power Sockets Plug in devices to be controlled on/off, and a dimming function using
the minimum/maximum rotary controls (see 5 and 6)
13
IN —POWER—ON
Power Socket Connect to the mains power
14 Mains Fuse Fuse for protecting the RB-6
15 Mains Switch Switch for turning the device on and off
16 RESET Switch Press and hold while turning power on to reset the device to factory
default condition
17 TERM RS-485 Switch Push up to terminate the RS-485 bus (see Section 6.4 )
18 RS-485 3-pin Terminal
Block Connect to a controller equipped with an RS-485 port (see
Section 6.4 )