Kramer Electronics RB-6 - Manual (Page 18)

14 RB-6 - Connecting the RB-6
Figure 8: Device Properties Screen
7. Change the parameters as required.
8. To save the changes, click Save. To exit without saving the changes, click
Exit.
6.3 Connecting to the RB-6 via RS-232
You can connect to the unit via a crossed RS-232 connection, using for example,
a PC. A crossed cable or null-modem is required as shown in method A and B
respectively. If a shielded cable is used, connect the shield to pin 5.
Method A ( Figure 9 ) —Connect the RS-232 9-pin D-sub port on the unit via a
crossed cable (only pin 2 to pin 3 , pin 3 to pin 2 , and pin 5 to pin 5 need be
connected) to the RS-232 9-pin D-sub port on the PC.
Note: There is no need to connect any other pins.