Kramer Electronics RB-6 - Manual (Page 22)

18 RB-6 - Operating the RB-6 Locally
To reset the lower and upper ranges for outputs 5 and 6 to the default values
of 0% and 100%:

Press and hold both the Min and Max buttons of the relevant output at the
same time.
The minimum is set to 0% and the maximum is set to 100% and the button
LED no longer lights
Note: When a Max or Min button LED is not lit it indicates that the settings are the
default values. When a Max or Min button LED lights it indicates that there is a
custom setting.
7.2 Resetting the RB-6 to Factory Defaults
To reset the device to factory defaults:
1. Turn the device off.
2. Press and hold the Reset button on the rear panel of the device, (see
Figure 1 ).
3. While holding the button depressed, turn the device on.
4. Wait a few seconds and release the button.
The configuration is reset to the factory default (see Section 11 ).