KMW Communications AMS Lite - Manual (Page 12)

Sheet 12 of 30 Sheet 12 of 30 8/17/2008
©
CONFIDENTIAL
Setup Date TICU installation date YYMMDD
Maker TICU manufacturer 2Byte
Serial TICU Serial NO. 17Byte
Model TICU Model 15Byte
Make Date TICU Make Date YYMMDD
ROM Ver TICU S/W Version
Field Control On-site : Yellow on, Not On-site : Yellow off RS-232 on-site control
IP Address TICU IP Address
Gateway TICU Gateway
Subnetmask TICU Subnetmask
Port TICU TCP Port
Server IP Server IP ( PC Application) Server IP
Server Port Server TCP Port Server port
) ALD control and monitor commands
Monitors and controls ALD (please refer to AISG v2.0 for more information).
Table – ALD control command
ITEM Description Remark
Set Assign Sets ALD ID Range : 1 ~ 254
Connect ALD Connect RET , TMA
Disconnect ALD Disconnect RET , TMA
Get Subunits No. Gets information of TMA Subunits number TMA only
Reset(Layer 7) ALD reset : Layer 7 RET ,TMA
Alarm Subscribe Enables Automatic Alarm Polling RET ,TMA
Get Alarm Status Gets Alarm status RET ,TMA
Get TMA Alarm Gets TMA Alarm Codes TMA only
Get Info Gets H/W and S/W info RET ,TMA
Clear Alarm ALD Alarm Clear RET ,TMA
TMA Clear Alarm TMA Alarm Clear TMA only
GetDeviceData (Ant) Gets Device Data for antenna RET only
GetDeviceData (TMA) Gets Device Data for TMA TMA only
GetDeviceData (Oper) Gets Device Data for operation RET only
Calibration Calibrates antenna RET only
Set Tit / Steering Sets Tilt / Azimuth of antenna RET only
Get Tilt Gets current tilt value RET only