KMW Communications AMS Lite - Manual (Page 15)

Sheet 15 of 30 Sheet 15 of 30 8/17/2008
©
CONFIDENTIAL
<Figure 6-3>
) Port setting
When “Port Set” is clicked (Figure 6-4), screen will display a window shown in Figure 6-5.
<Figure 6-4>
<Figure 6-5>
Set Baudrate to 115200bps, Databit to 8bit, Paritybit to None, and Stopbit to 1bit.
Then click Update. PORT shows current port dedicated for the communication. Serial port is
only used to controller and device on site.
) Console (Data Log) Window
When “Console” (Figure 6-6) button is clicked, window will display (Figure 6-7). The window displays
the status of TX / RX data, which is sent to, and received from PC and AMS software (refer to Table-
AISG ERROR CODE, and AMS ERROR CODE for detail error code description). This window also
displays the status of TX / RX data, which is sent to and received from PC and TICU.