KMW Communications AMS Lite - Manual (Page 20)

Sheet 20 of 30 Sheet 20 of 30 8/17/2008
©
CONFIDENTIAL
<Figure 7-2>
Table-Initial Setting List
ITEM Description Remark
ID
TICU Primary Key
When the PC sends a data to TICU, the TICU will
ignore the data in the case of ID mismatch.
ID Range: 1 ~ 65535
Maker
TICU manufacturer ’s ID
Refer to AISG v2.0 Annex A : Assigned
Vendor Codes
2Byte
Serial TICU Serial number 17byte
Model TICU Model 15Byte
Make Date TICU manufacture date “YYMMDD”
) Set Device Data
When “Set Device Data” (Figure 7-1) button is clicked, window will be displayed (Figure 7-3). You can
input the operation parameter, but only checked data will be transferred to the TICU.
Refers to Table “Set Device Data List”.
If you click the “Write” button, the data will be transferred to the TICU. When we use the Ethernet
interface, PC sends the data to the IP address at the TICU local network settings. And the TICU also
responds to the IP address at the Server Environment settings. However it is not possible to change
Local Network and Server Environment in the AMS Lite Version.