Seiwa Tigershark Plus - Manual (Page 54)

56 User Manual
C-Link navigation data can refer to:
- Single Destination navigation
- Route Following navigation.
Values identified by (*) are sent only for Route Following navigation.
The Destination Icon, Navigation leg (Fix Position to Destination), the Next Way-
point Icon and all other relevant C-LINK navigation data will be shown on the
Slave chart plotter. Any variation of the C-Link navigation data on the Master will
be communicated to the Slave so to keep data aligned on both devices.
MASTER CHART PLOTTER
Operating mode
To select the Master mode follow the procedure:
[MENU] + [MENU] + "ADVANCED" + [ENTER] + "C-LINK" +
[ENTER] + "Primary Station" + [ENTER]
Master mode is the default factory setting.
All regular chart plotters’ functions are allowed.
As soon as the Destination is placed, the master chart plotter will start transmit-
ting all C-LINK navigation data,
In Master mode the C-Link navigation data received from the NMEA port is ig-
nored. So, if the two chart plotters are both operating in Master mode, the C-Link
navigation data sent by the other Chart Plotter never processed.
Under such condition if the navigation is activated on one of the two Chart Plot-
ters, a warning message will be shown to notify that the C-Link navigation data
will be ignored by the other Chart Plotter.
SLAVE CHART PLOTTER
Operating mode
To select the Slave mode follow the procedure:
[MENU] + [MENU] + "ADVANCED" + [ENTER] + "C-LINK" +
[ENTER] + "Secondary Station" + [ENTER]
When Slave mode is set, the chart plotter cannot manipulate the C-Link naviga-
tion data anymore.
Stop current navigation
If the navigation was already active, it will be disabled as soon as Slave mode is
set. An appropriate warning message will be shown to notify that the Navigation
is already active and to confirm whether Slave mode can be set.
Inhibit Navigation operation
As soon as Slave mode is set, the destination cannot be set anymore either the C-
Link navigation data is received from the Master or not. Also, when the C-Link
navigation data is received from the Master, it will not be possible to deactivate
the Navigation.
Inhibit Route following
While navigating to the route received from the Master the destination is reached
(either applying distance or perpendicular criteria), the destination will not be
moved to the next Waypoint on the route.
MOB handling
If the Navigation to the external destination is active and the MOB key is pressed
on the Slave Chart Plotter, the MOB is placed but the navigation to the MOB is not
activated.
NOTE While navigating to the external destination the Operating Mode is switched
to Master mode, the navigation to the external destination will be terminated.
An appropriate warning message will be shown to notify that the Navigation
to the external destination is active and to confirm whether Slave mode can
be set. Setting Slave mode, the C-Link navigation data will be deleted.
The C-Link navigation data are deleted at Power Off.