Lenovo ThinkServer RD550 - Manual (Page 137)

3. Pull the handle and carefully slide the dummy hard-disk-drive tray out of the front of the chassis.
Figure 96. Removing the dummy hard-disk-drive tray
4. Touch the static-protective package that contains the 2.5-inch solid-state drive to any unpainted surface
on the outside of the server. Then, take the solid-state drive out of the package.
Note: Do not touch the circuit board on the solid-state drive.
5. Position the 2.5-inch solid-state drive into the 3.5-inch to 2.5-inch drive adapter as shown in the
following illustration.
Figure 97. Positioning the 2.5-inch solid-state drive into the drive adapter
Chapter 6 . Replacing hardware 123