APPLIED ENGINEERING Vulcan - Manual (Page 10)

5 ) Insert Vulcan
i) Insert bock end first.
Align the three holes in the back of the Vulcan with the three
prongs in the back of the computer.
ii) Snap down Into front tab.
Push down on the front of the Vulcan until the plastic tab on the
computer case snaps into the hole at the bottom front of the
Vulcan. You should hear the tab snap into place.
Snap Vulcan Into Front Tab
6 ) Plug Internal Power Cord Into Motherboard.
The Vulcan’s internal power cord plugs into the motherboard in
the same place as the old power supply’s cord. The connector’s
tab should be toward the right side of the computer.
• Note: Do not force the connector; it will plug in easily
in one direction.
Plug Internal Cord Into Motherboard
Ch.I - IIGS Instollation 3