APPLIED ENGINEERING Vulcan - Manual (Page 48)

• Note: If you don’t have a list of what files are on what
disks, you can list the contents of each disk following the
instructions under the Listing Files section above.
3) From Backup II’s main menu, press the R key on your
keyboard. This selects the RESTORE VOLUME option.
B - BACKUP FILES
R - RESTORE FILES
Q - QUIT
PLEASE SELECT AN OPTION
4) Press P to select RESTORE BY PATHNAME.
V - RESTORE VOLUME
P - RESTORE BY PATHNAME
L - LIST FILES
SELECT AN OPTION OR <ESC>:
5) At the RESTORE FROM -- prompt, type in the slot
number of your floppy drive (usually “5” for 3.5”
drives.)
6) Now type in the drive number of your floppy drive
(usually 1, however, the 3.5” drive number will be 2 if
you’re booting from a RamKeeper).
RESTORE FROM --
(SLOT 5 DRIVE 1)
7) You’ll then be given the pathname of the disk in the
floppy drive, ex:
RESTORE FROM ——
(/BACKUP .VOLUME11/
8) Enter the pathname of the file or directory you want to
restore, ex:
RESTORE FROM --
(/BACKUP .VOLUME11/MY.FILES
In this example, if MY.FILES was a directory, the entire
directory would be restored.
9) Press <return>.
Ch. 5 - Backing Up the Vulcan 41