APPLIED ENGINEERING Vulcan - Manual (Page 58)

Remote Light Jack
In addition to the on-board LED, there is a two pin connector for
a remote drive activity indicator LED.
Applied Engineering offers an LED extension option. Call Æ
Sales to order at (214) 241-6060.
If you’re so inclined, you can make an extension light to run
from the connector and attach it under the front panel next to
the green LED. Make sure that no wires are exposed; any
exposed wires may short out the motherboard.
* Warning: Applied Engineering is not responsible for
any damage resulting from modifications to your
computer.
The connector is wired as follows:
Pin 1 (the right pin when facing the board from the chip
side right side up) Anode of the LED
Pm 2 Cathode of the LED
With the lid off, remove the front panel by releasing the three
tabs under the front edge of the computer.
Note the “pocket” in back of the clear window on the underside
of the front panel where the green LED shines through. It is
possible to fit an LED into this pocket.
App. D - Hardware 51