APPLIED ENGINEERING Vulcan - Manual (Page 8)

CHAPTER ONE
IIGS Installation
Installation Procedure
You’ll need no special tools to install the Vulcan. Simply follow
the instructions below.
1 ) Open Computer
Press in the two latches at the rear of the case with your
forefingers while using your thumbs to push the lid up and
towards you. (See picture following.)
Remove the IIGS cover
2 ) Remove Power Supply
i) Remove slot one card.
If you have a card installed into slot 1, you’ll need to remove it to
give yourself room to reach the internal power plug. Refer to
your slot 1 card’s manual for proper removal.
ii) Unplug external cord from back of computer.
This is the cord that runs from the back of the computer to the
wall socket. Unplug it from the back of the computer and from
the wall socket as well.
iii) Unplug internal cord from motherboard.
The internal power cord is the multi-wire cord running from
the power supply toward the back of the motherboard. Pull up
firmly on the white plastic part of the plug.
Ch. 1
-
IIGS Installation