APPLIED ENGINEERING Vulcan - Manual (Page 13)

1 0 ) ReInstall Any Cards Removed
Replace any cards you have removed for the installation
following those cards’ installation instructions.
• WARNING! IF YOU HAVE A CARD IN SLOT 1 , use
the insulator card (2” x 6”) included with the Vulcan
package. Applied Engineering will not be responsible
for damage to any other products so be careful when
reinstalling your cards.
1 1 ) Close Computer
Replace the lid by sliding the front of the lid in first, lowering the
back edge into place and then pushing gently and firmly on the
back corners of the lid until it pops into place.
1 2 ) Plug In External Power Cord
This is the same cord as your original power supply used.
Connect it to the back of the Vulcan and then plug it into the
wall socket.
1 3 ) Boot Computer and Set Slots
You must set the slot containing the controller card to “Your
Card” under Slots option of the Control Panel. Refer to your IIGS
owner’s manual for more information on setting the slot.
Slot 7 Exception (Pseudo-Slotting)
If you want the card to appear to be in slot 7 even though
it’s installed into another slot (as mentioned earlier) you’ll
need to set your slots as follows:
1) Leave the slot in which the controller card is
installed set to that slot’s function (i.e. not “Your
Card”)
2) Set slot 7 to “Your Card.”
• Note: Make sure that you’ve set the switches on
the card to the proper position.
1 4 ) Set to Boot from the Vulcan
The Vulcan is preformatted and ready to boot into GS/OS. If you
want to boot from the Vulcan, set the Startup Slot under the
Slots option to the slot that your Vulcan is in. (If you’re pseudo-
slotting, set Startup Slot to 7.)
Hardware installation is complete. Congratulations!
6 Vulcan