ADC MM701G - Manual (Page 123)

Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual 115
LLC header mode
Enter 8 then select either 1 to Enabled or 2 to Disabled the LLC header. The default is
Disabled . Disabled indicates that VCMux encapsulation is used. Enabled indicates that
LLC/Snap encapsulation is used.
WAN IP Address
Enter 9 then type the IP address is dynamically served by the service provider for this
session. When the modem has received the IP address for this session, it displays the
value in this field. Also, the IP address dynamically received for the first PPP session
set up is assigned as the default gateway (see
page 44 ). The default is 0.0.0.0.
If the service provider does not dynamically provide an IP address, they can give you
a static IP address that you can enter in this field.
WAN Network Mask
Enter 10 then type the subnet mask is dynamically served by the service provider for
this session. The default subnet mask for the session is 0.0.0.0.
If the service provider does not dynamically provide a subnet mask, they can give you
a subnet mask value that you can enter in this field.
RIP Accept Mode
Type 11 then select one of the following:
• 1 — No RIP
• 2 — RIP Version 1
• 3 — RIP Version 2
• 4 — RIP Version 1 & 2 (default)
RIP Send Mode
Type 12 then select one of the following:
• 1 — No RIP
• 2 — RIP Version 1
• 3 — RIP Version 2 (default)
• 4 — RIP Version 1 & 2