ADC MM701G User Manual

Page 158

Advertising
background image

150

MM701G and MM702G User Manual

community
string

A text string required for an SNMP trap to be received by a trap receiver(s). Also, a
text string that identifies an SNMP community and is associated with specific access
rights (read-only or read/write).

CRC

Cyclic Redundancy Check is a method used to verify the accuracy of data
transmission.

DHCP

Dynamic Host Configuration Protocol. A TCP/IP protocol that enables PCs to obtain
IP addresses from a DHCP server that dynamically assigns IP addresses.

DNS

Domain Naming System. A system for translating names of host computers into IP
addresses.

downstream
traffic

Communications from a service provider to a user.

encapsulation

The inclusion of data in a protocol header prior to transmission, which enables
successful data transmission between different protocol networks.

ES

Errored Seconds is the seconds during which errors occur that prevent the payload
from being corrected.

Ethernet

A protocol used for LAN traffic, which has a transfer rate of 10 or 100 Mbps.

flash memory

Non-volatile memory that can be erased and reprogrammed.

G.shdsl

Symmetrical High-Speed Digital Subscriber Line

gateway

A device (generally a router) that provides translation services to allow
communication between two dissimilar networks.

IP

Internet Protocol is a TCP/IP protocol that controls packet transmission.

IP address

A 32-bit address used in IP routing. The address consists of four octets separated by
decimals. The octets comprise a network section, a subnet section (optional) and a
host section.

LAN

Local Area Network is a physically connected group of devices between which data
transmission occurs at high speeds over relatively short distances.

LLC

Logical Link Control is an encapsulation protocol for data that you transmit from the
modem over the WAN in 1483 Bridging/Routing mode.

LOF

Loss Of Frame is an error indicating that the receiving equipment has lost a frame.

LOS

Loss Of Signal is an error indicating that the receiving equipment has lost the signal.

Advertising
This manual is related to the following products: