Configure g.shdsl parameters, Complete a quick configuration – ADC MM701G User Manual
Page 127
Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual
119
Configure G.shdsl Parameters
You can complete either a quick configuration or an advanced configuration for the G.shdsl line
parameters. The following sections provide procedures for each configuration type.
Complete a Quick Configuration
1
From the
G.SHDSL Menu
, enter
2
to display the
G.SHDSL Quick Configuration
menu.
2
Configure the following parameters as directed by your service provider:
Operating Mode
Type
1
then select
1
for
Remote
and
2
for
Central-Office
.
When the modem is connected to a service provider through a DSLAM, the operating
mode is
Remote
(default setting). When two modems are used in a point-to-point
application (LAN extension, for example), one modem at the customer or user site is
set to
Remote,
and the second modem in the CO or wiring closet is set to
Central-Office
.
For instruction on setting up G.shdsl parameters and other related parameters for a
point-to-point modem application, go to Chapter 7, “Implementing a Point-to-Point
LAN Extension.”