Access through a telnet session – ADC MM701G User Manual
Page 111
Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual
103
Access through a Telnet Session
To access the modem through a LAN-side telnet session, ensure that the management PC is on
the same IP subnet as the modem (see
“Accessing the Web Interface for Modem Management”
); you will specify the LAN port IP address (default LAN IP address is 10.0.0.1 and
subnet mask is 255.255.255.0) for access. To access the modem through a WAN-side telnet
session, ensure that at least one WAN session has been set up for the modem; you will specify
the IP address set up for that WAN session for access.
Below is an example using the telnet application in Microsoft Windows 98 SE to access the
modem command-line interface:
1
From the
Start
button, select
Run
to display the
Run
dialog. Or, open your telnet application
2
In the
Open
box, enter the
telnet
command and the modem IP address (for example,
10.0.0.1), then click
OK.
The Windows telnet dialog is displayed.
3
At the prompt, enter your
Login
and
Password
. The
System Management
main menu is
displayed.
Although you can have concurrent telnet and console port sessions to the
command-line interface, you can make changes through only one of the
interfaces at a time.
M0023-A
Modem Defaults
Login
admin
Password
password