ADC MM701G - Manual (Page 121)

Appendix A: Accessing the Command-Line Interface
MM701G and MM702G User Manual 113
Set Up a PPPoA or PPPoE Routed Session
You selected Create PPPoA routed session or Create PPPoE routed session from the WAN Session
Management menu to display the following menu. The PPPoA routed session configuration
is shown below as an example. The configuration parameters for PPPoE routed session are
identical.
1 Configure the following parameters, 1 through 15, for the PPP session:
Session Name
Enter 1 then type a unique, descriptive identifier for the session. This name can have a
maximum of 32 characters.
Virtual Path ID (VPI)
Enter 2 then type the value (from 0 to 4,095) provided by the service provider. The
number identifies the virtual path that transports ATM cells between the modem and
the service provider. This value must match the virtual path identification (VPI) value
the service provider uses for this connection.
Virtual Channel ID (VCI)
Enter 3 then type the value (from 32 to 65,535) provided by the service provider. The
number identifies the virtual channel for this session that transports ATM cells
between the modem and the service provider. This value must match the virtual
channel identification (VCI) value the service provider uses for this connection.