ADC MM701G - Manual (Page 86)

Configure NAT
78 MM701G and MM702G User Manual
C
ONFIGURE
NAT
NAT provides the ability to map private IP address on the LAN to
public IP addresses (WAN) that are assigned to each session.
This essentially hides the private IP addresses behind the public
IP addresses assigned to WAN sessions. Prior to binding NAT to a
WAN IP address, you should have previously set up PPPoA routed, PPPoE routed, or RFC 1483
routed WAN sessions (see
“Configure a New WAN Session” on page 26 ). You cannot
configure NAT for RFC 1483 bridged sessions.
1 Select System on the menu bar, then select SmartCNCTSecurity under [Configuration] to access
the Security Interface Configuration page.
SmartCNCTSecurity
System