Agilent Technologies 6631B - Manual (Page 55)

Language Dictionary - 4
55
Output Commands
Output commands consist of output and source commands.
Output commands control the output and digital port functions. They also control the output relay on
units with Relay Option 760.
Source commands program the actual voltage, current, and digital port output.
OUTPut
This command enables or disables the dc source output. The state of a disabled output is a condition of
zero output voltage and a model-dependent minimum source current (see *RST). Unless the NORelay
command is programmed, the OUTput command also controls the output relay on Agilent models
66332A, 6631B, 6632B, 6633B, and 6634B with Relay Option 760. If the NORelay command is sent, the
output relay state does NOT change.
Command Syntax OUTPut[:STATe] <bool> [,NORelay]
Parameters 0 | OFF | 1 | ON
*RST Value 0
Examples OUTP 1OUTPUT:STATE ON
Query Syntax OUTPut[:STATe]?
Returned Parameters <NR1>0 or 1
Related Commands *RST *RCL *SAV
OUTPut:DFI
This command enables or disables the discrete fault indicator (DFI) outputfrom the dc source.
Command Syntax OUTPut:DFI[:STATe]<bool>
Parameters 0 | 1 | OFF | ON
*RST Value OFF
Examples OUTP:DFI 1 OUTP:DFI ON
Query Syntax OUTPut:DFI[:STATe]?
Returned Parameters 0 | 1
Related Commands OUTP:DFI:SOUR
OUTPut:DFI:SOURce
This command selects the source for discrete fault indicator (DFI) events.The choices are:
QUEStionable selects the Questionable event summary bit (bit 3 of the Status Byte Register)
OPERation selects the Operation Event summary bit (bit 7 of the Status Byte Register)
ESB selects the Standard Event summary bit (bit 5 of the Status Byte Register)
RQS selects the Request Service bit (bit 6 of the Status Byte Register)
OFF selects no DFI source
Command Syntax OUTP:DFI:SOUR<source>
Parameters QUES | OPER | ESB | RQS | OFF
*RST Value OFF
Examples OUTP:DFI:SOUR OPER
Query Syntax OUTPut:DFI:SOUR?
Returned Parameters <CRD>
Related Commands OUTP:DFI