Olympus E-3 - Manual (Page 157)

157
EN
Inf
o
rm
a
tion
12
• Do not push the monitor forcibly; otherwise the image may become vague, resulting in a playback mode failure
or damage to the monitor.
• A strip of light may appear on the top / bottom of the monitor, but this is not a malfunction.
• When a subject is viewed diagonally in the camera, the edges may appear zigzagged on the monitor. This is
not a malfunction; it will be less noticeable in playback mode.
• In places subject to low temperatures, the LCD monitor may take a long time to turn on or its color may change
temporarily. When using the camera in extremely cold places, it is a good idea to occasionally place it in a warm
place. An LCD monitor exhibiting poor performance due to low temperatures will recover in normal
temperatures.
• The LCD used for the monitor is made with high-precision technology. However, black spots or bright spots of
light may appear constantly on the LCD Monitor. Due to its characteristics or the angle at which you are viewing
the monitor, the spot may not be uniform in color and brightness. This is not a malfunction.
• Do not immerse in water or splash with water.
• Do not drop or exert strong force on the lens.
• Do not hold at the moving part of the lens.
• Do not touch the lens surface directly.
• Do not touch the contact points directly.
• Do not subject to abrupt temperature changes.
• Do observe the operating temperature limit.
• Olympus makes no representations or warranties regarding any damages, or benefit expected by using this
unit lawfully, or any request from a third person, which are caused by the inappropriate use of this product.
• Olympus makes no representations or warranties regarding any damages or any benefit expected by using
this unit lawfully which are caused by erasing picture data.
• Olympus makes no representations or warranties, either expressed or implied, by or concerning any content
of these written materials or software, and in no event shall be liable for any implied warranty of merchantability
or fitness for any particular purpose or for any consequential, incidental or indirect damages (including but not
limited to damages for loss of business profits, business interruption and loss of business information) arising
from the use or inability to use these written materials or software or equipment. Some countries do not allow
the exclusion or limitation of liability for consequential or incidental damages, so the above limitations may not
apply to you.
• Olympus reserves all rights to this manual.
Unauthorized photographing or use of copyrighted material may violate applicable copyright laws.
Olympus assumes no responsibility for unauthorized photographing, use or other acts that infringe upon
the rights of copyright owners.
All rights reserved. No part of these written materials or this software may be reproduced or used in any
form or by any means, electronic or mechanical, including photocopying and recording or the use of any
type of information storage and retrieval system, without the prior written permission of Olympus. No
liability is assumed with respect to the use of the information contained in these written materials or
software, or for damages resulting from the use of the information contained therein. Olympus reserves
the right to alter the features and contents of this publication or software without obligation or advance
notice.
LCD Monitor
Lens
Legal and Other Notices
Disclaimer of Warranty
Warning
Copyright Notice