Olympus E-3 - Manual (Page 64)

64
EN
4
Focusing
an
d shooti
ng functio
n
s
Setting display
Checking the image stabilizer effect with live view
You can hold down the o button during live view to see
the effect of the image stabilizer on the monitor. While in
that position, you can press the shutter button fully to take
a picture.
• When [IMAGE STABILIZER] is set to [OFF], pressing and
holding the o button activates the image stabilizer ([I.S. 1]).
• Either releasing the o button or holding down the o button
for several seconds turns off the image stabilizer.
x
Notes
• The image stabilizer cannot correct excessive camera
shake or camera shake that occurs when the shutter
speed is set to the slowest speed. In these cases, it is
recommended that you use a tripod.
• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilization function
of either the lens or the camera.
• Turning off the camera initializes the image stabilizer function. The camera will vibrate for this
operation, but this is not a malfunction.
• A red H displayed on the monitor indicates the failure of the image stabilizer function. If you
take a picture as is, the composition may be off. Consult your Olympus Authorized Service
Center.
: OFF
: I.S. 1
: I.S. 2 Viewfinder
Control panel
Green : Image stabilizer active
Red
: Image stabilizer failure
250 250 F5.6 F5.6
1 IS IS
L N N
38 38
E-3_MASTER.fm Seite 64 Freitag, 19. Oktober 2007 2:17 14