Pioneer AVIC-HD3 - Manual (Page 167)

165
A
ppe
n
d
ix
NA
V
I/A
V
If system errors frequently occur
If system errors frequently occur and the power
to the navigation system turns off, inappropriate
content may have been recorded in the memory
or the hard disk drive. In such a case, normal
operations may be restored by clearing the set-
ting values stored in the hard disk drive. For the
contents that are cleared, see the list presented
later.
1
Start the engine.
After a few moments, the start-up screen
comes on for a few seconds.
2
Touch and hold the MAP button while the
start-up screen is displayed.
“Clear memory screen” appears.
3
Touch [Reset].
4
Touch [Yes].
The setting values stored in the hard disk drive
return to the default or factory settings. After
that, the navigation splash screen appears.
Completely returning the navi-
gation system to the initial state
To return the entire navigation system to the
default or factory settings, initialise the naviga-
tion system in the following order:
1
Turn the ignition switch off.
2
Press the RESET button.
3
Start the engine.
After a few moments, the start-up screen
comes on for a few seconds.
4
Touch and hold the MAP button while the
start-up screen is displayed.
“Clear memory screen” appears.
5
Touch [Clear user information from hard
disk].
❒
This reset operation clears all music data
recorded in the music library. Note that the
cleared data cannot be restored.
6
Touch [Yes].
The user area in the hard disk drive is initial-
ised. After that, the navigation system
restarts.
Audio functions
Music Library
[LIBRARY]
Repeat, Random settings ✓ – ✓ ✓
Track data – – – ✓
Playlist – – – ✓
Last playback position – – – ✓
[DVD] All settings ✓ – – –
[CD] All settings ✓ – – –
[ROM](MP3) All settings ✓ – – –
[FM] Preset memory and the other settings ✓ – – –
[AM] Preset memory and the other settings ✓ – – –
[TV] Preset memory and the other settings ✓ – – –
[REAR
SCREEN]
Rear Screen setting ✓ – – –
Others Picture Adjust ✓ – – –
Displayed Tilt ✓ – – –
Method 1 Method 2 Method 3 Method 4
1. Press the RESET button on the hard-
ware.
2. Initialise the user data area on the hard
disk drive.
3. Clear the learned data in the sensor.
MAN-HD3-SOFTW-EN.book Page 165 Wednesday, January 10, 2007 9:33 AM