Pioneer AVIC-HD3 - Manual (Page 182)

180
Appe
n
d
ix
NA
V
I/
A
V
Messages for Audio Functions
When problems occur in the audio source, a message may appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Centre.
Built-in DVD drive
Hard disk drive (Music Library)
Message When What to do
Unreadable disc. If you try to use a disc which is incom-
patible with this system.
Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise dam-
aged.
Insert a normal, round disc.
Mechanical failure of DVD drive occurs. Consult your Pioneer dealer.
Playback error.
Please remove the disc.
Electrical or mechanical error has
occurred.
Press the RESET button. (“Hardware
manual” after reading page 163 in this
manual.)
Region code error The disc does not have the same region
number as the navigation system.
Replace the DVD-Video with one bearing
the correct region number.
Playback error due to irregu-
lar temperature. Please
remove the disc.
The temperature of the built-in DVD
drive exceeds the operating limits.
Park your vehicle in safe place, turn the
ignition switch off, and wait until the
built-in DVD drive’s temperature returns
to within normal operating limits.
ATTENTION!
Viewing of front seat video
source while driving is strictly
prohibited.
Handbrake interlock is activated. Park your vehicle in the safe place and
apply the handbrake.
➲
Handbrake interlock ➞ Page 18
Search error The title number, chapter number, time,
or 10 key command that you enter in
[10Key Search] do not exist. (This mes-
sage will appear when the DVD drive
cannot accept that command.)
Enter the available numbers or 10 key
command or use another search
method.
Message When What to do
This CD cannot be recorded If you insert a CD which prohibits sec-
ond-generation copies or duplicate.
Use another CD and retry.
• Recording error.
Switching to CD playback
mode
• Recording error.
Recording is stopped
• The recording was unsta-
ble. Restart the recording
from the beginning of the
track.
If recording can not be carried out due
to continuous skipping on certain part of
the disc because the disc is dirty,
scratched, or otherwise damaged, the
pick-up lens of the DVD drive is dirty, or
extreme vibration occurs continuously.
• Clean the disc and retry.
• Clean the pick-up lens with a commer-
cially available cleaning kit for DVD, then
retry.
• Retry in vibration-free condition.
Exceeded playlist maxi-
mum. No more playlists can
be recorded.
If you try to record a new CD but the
maximum number of playlists are
already recorded. (The album playlist
can be stores up to 400.)
Delete some playlists and retry.
Playback error. Music
Library cannot be played
The music library component is abnor-
mal.
Consult your dealer.
This playlist cannot store
more than 99 tracks.
If you try to add tracks but the My Mix or
My Favourite playlists are maximum
number. (The My Mix and My Favourite
playlists can store the tracks up to 99.)
Delete some tracks and retry.
MAN-HD3-SOFTW-EN.book Page 180 Wednesday, January 10, 2007 9:33 AM