Pioneer AVIC-X3 - Manual (Page 128)

126
Ap
p
en
d
ix
NA
V
I/
A
V
location where the vehicle re-entered the area
stored on the disc.)
Major restrictions during the
memory navi mode
• The scale cannot be zoomed freely.
• If a route was set to your destination in mem-
ory navi mode, inserting the DVD Map Disc
automatically starts recalculation of another
route. (You cannot cancel this reroute opera-
tion. If the route calculation fails for some rea-
son, a message will appear asking you to either
recalculate a route (Reroute) or delete the cur-
rent route (Delete route). In this case, drive for
a while before touching either “Reroute” or
“Delete route” to delete the current route, then
reset the destination.)
• In some cases, you may not be able to use map
display mode during DVD navi mode. If the
map display mode is not changed during
memory navi mode, the display will return to
the map display mode used during the DVD
navi mode when the DVD Map Disc is set
again.
• In memory navi mode, map scale data that
cannot be read in the memory cannot be dis-
played. Accordingly, the edge of the map will
appear cut off along the point it was not read
into memory. This simply indicates the edge of
the map data, and is not a malfunction.
• If you keep driving or scrolling the map to a
point where the map can no longer be dis-
played, the scale automatically switches to a
range possible to display. If you would like to
continue driving or scrolling the map at the
same scale, set the DVD Map Disc in the navi-
gation system.
• You cannot reroute to avoid traffic jam or clo-
sure.
• If you continue to drive outside the route for a
while, you may not be able to perform map
matching.
• If you deviate from the route during memory
navi mode, the set route will be rerouted, but
only to return you to the original route calcu-
lated within the memorised area.
• Although an enlarged map of the intersection
will be displayed, no special motorway illustra-
tion (illustration of motorway junctions) will be
displayed.
Cautions relating to auto reroute
in memory navi mode
Auto rerouting in memory navi mode is designed
to return you to your original route wherever pos-
sible.
In memory navi mode, persistently deviating from
the route may result in one of the following:
• A clearly circuitous route
• Leaving a toll road and returning to the toll
road from where you left it.
In the above case, if the set route seems unsuita-
ble, insert the DVD Map Disc. Setting the DVD
Map Disc to navigation automatically resets the
route from your current location to your destina-
tion.
TMC icon during the memory
navi mode
• TMC-related data for only one country can be
memorised. Therefore, if appears on
the screen when crossing an international bor-
der, you will need to insert the disc to use the
RDS-TMC function. Touching
allows
you to check the locations of the traffic infor-
mation along the route. However, you cannot
perform rerouting.
Operation outside the memo-
rised area
When the vehicle leaves the memorised area, the
functions will be limited.
• The auto reroute function does not work.
• You can only display a larger scale map. The
map display will automatically change to a
50 km (or 100 km) scale.
• The map matching function will not be availa-
ble. Therefore, the position of your vehicle may
be misaligned.
• The navigation guidance will only be available
when arriving at your destination. Other guid-
ance is not possible (this includes no display of
direction arrows).
MAN-AVIC-X3-EN.book Page 126 Wednesday, June 6, 2007 10:15 AM