Pioneer AVIC-X3 - Manual (Page 22)

20
Ch
ap
te
r
1
Ba
sic
Op
er
at
ion
NA
V
I/
A
V
Flow from Startup to Termina-
tion
❒ If the programme is not installed, see page
122 and install the programme.
1
Start the engine.
The navigation system is also turned on.
After some time, the navigation opening
screen comes on for a few seconds. Then, a
message screen is displayed.
❒
Insert the Pioneer DVD Map Disc to the
disc loading slot.
2
Check the details of the caution message
and touch “OK”.
You can operate the navigation system by
touching keys displayed on the screen.
The map of your surroundings is displayed.
3
Turn off the vehicle engine.
This navigation system is also turned off.
❒
This product also can be switched off by
turning the ACC (ignition) OFF.
Inserting/Ejecting a Disc
Inserting a disc
1
Insert a disc into the disc loading slot.
❒ The DVD drive plays one standard 12-cm or
8-cm (single) disc at a time. Do not use an
adapter when playing 8-cm discs.
❒ Do not insert anything other than a disc
into the disc loading slot.
Ejecting a disc
1
Press the EJECT button.
The disc is ejected.
Opening and Closing the LCD
Panel
• Do not close the LCD panel with hands by
force. This may cause malfunction.
• Keep hands and fingers clear of the dis-
play unit when opening, closing, or adjust-
ing the LCD panel. Be especially cautious
of children’s hands and fingers.
The LCD panel will open or close automatically by
turning the ignition switch on or off. You can turn
off the automatic open/close function.
• The automatic open/close function will operate
the display as follows:
– When the ignition switch is turned OFF
while the LCD panel is open, the LCD panel
will close after a few moments.
– When the ignition switch is turned ON again
(or turned to ACC), the LCD panel will open
automatically.
– Removing or attaching the front panel will
automatically close or open the LCD panel.
➲ Removing the front panel ➞ Page 22
• When the ignition switch is turned OFF after
the LCD panel has been closed, turning the
ignition switch ON again (or turning it to ACC)
will not open the LCD panel. In this case, press
the OPEN/CLOSE button to open the LCD
panel.
• When closing the LCD panel, check to make
sure that it has closed completely. If the LCD
panel has stopped halfway, leaving it like this
could result in damage.
1
Press the OPEN/CLOSE button to close
the LCD panel.
❒
To open the LCD panel, press the OPEN/
CLOSE button again.
MAN-AVIC-X3-EN.book Page 20 Wednesday, June 6, 2007 10:15 AM