Pioneer AVIC-X3 - Manual (Page 23)

21
Ch
ap
te
r
1
Ba
sic Op
er
at
io
n
NA
V
I/A
V
Setting the LCD panel
Adjusting the LCD panel angle
1
Press and hold the OPEN/CLOSE button.
The Flap Setup screen appears.
2
Press the 7 or 9 button to adjust the
LCD panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you keep pressing and holding the
7 or 9 button.
3
Touch “ESC”.
When Flap Setup is displayed during the
navigation screen, the map screen is dis-
played.
When Flap Setup is displayed during the AV
screen, the current AV operation screen is dis-
played.
❒
If you can hear the LCD panel knocking
against your vehicle’s console or dash-
board, press the 7 button to move the
LCD panel slightly forward.
❒ When adjusting the LCD panel angle, be
sure to press the 7 or 9 button. Manu-
ally adjusting the LCD panel by hand may
damage it.
❒ The adjusted the LCD panel angle will be
memorised and LCD panel will automati-
cally return to this angle the next time the
LCD panel is opened.
Setting the slide back function
You can adjust the LCD panel slide position to
prevent the display from hitting the gearstick of
an automatic vehicle when it is in P (park) posi-
tion.
❒ Please be careful, as LCD panel will slide
immediately after the setting is turned “On”.
1
Press and hold the OPEN/CLOSE button.
The angle adjustment screen appears.
2
Touch “Flap Set Back”.
Touching “Flap Set Back” switches between
“On” and “Off”.
MAN-AVIC-X3-EN.book Page 21 Wednesday, June 6, 2007 10:15 AM