Pioneer AVIC-X3 - Manual (Page 139)

137
Appe
n
d
ix
NA
V
I/A
V
Problems in the audio screen (during iPod playback)
Messages and how to react to them
The following messages may be displayed by your navigation system.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Symptom Cause Action (See)
Cannot be operated. The iPod is frozen. Reconnect the iPod with the inter-
face cable for iPod ® (sold sepa-
rately).
The authorisation error has occurred. • Reconnect the iPod with the inter-
face cable for iPod ® (sold sepa-
rately).
• Set the ACC to Off and set it to On
again.
• Update the iPod version.
Message When What to do
Please insert the appropriate disc.
This is not the appropriate disc.
Please insert the appropriate disc.
If you try to use a disc which is
incompatible with this system.
Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise
damaged.
Insert a normal, round disc.
Irregular speed pulse signal is
detected. Please turn system power
off and check the installation. After
checking, please re-boot the system
and press “OK”.
If the Navigation system does not
receive the vehicle speed pulse.
Consult your Pioneer dealer.
Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration is detected. Please turn
system power off and check the
installation. After checking, please
re-boot the system and press “OK”.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
Direction of G sensor is not correct.
Please turn system power off and
check the installation. After check-
ing, please re-boot the system and
press “OK”.
Direction of G sensor is set incor-
rectly.
See the “Installation Manual” and set
the direction of the navigation unit
correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
Abnormal output is detected from
the Gyrosensor.
Note down the error code shown on
the screen. Turn off the power, and
then contact your nearest Pioneer
service facility.
This function is not available now. The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
If the sensor learning status reaches
the Sensor Initialising status, the sys-
tem is ready to be used.
MAN-AVIC-X3-EN.book Page 137 Wednesday, June 6, 2007 10:15 AM