02 install your flat panel display, 7 connect the power cord to the panel, 8 route then bundle the power cord and cables – Pioneer KRP-500M User Manual
Page 22
22
En
02
Install Your Flat Panel Display
2.7
Connect the Power Cord to the Panel
Attach the Ferrite Core
To help prevent noise, attach the supplied ferrite core to the connector end of the power cord as shown in the
diagram below. Use the supplied cable tie to prevent the ferrite core from slipping on the cable.
If it is already attached, do not remove the ferrite core from the power cord. It should be permanently attached.
If you do not do this, this display will not conform to mandatory CE standards.
The final connection is the power cord. Always connect the panel’s power cord to a three-pronged outlet, verifying
that the cord is properly grounded. The cord includes a noise filter that reduces electrical interference from the
wall outlet.
As long as the flat panel display is plugged in to an outlet, some power is drawn through the panel. When the flat
panel display is not going to be used for a long period, unplug the panel from the power outlet. Unplugging the
panel extends the life of the plasma as well as saves energy.
Plug the cord in to the panel but do NOT plug it in to a power outlet yet.
2.8
Route then Bundle the Power Cord and Cables
Once the flat panel display is mounted, place additional equipment in the final position(s). Lay out the power cord,
panel cables, and any other device cables in a logical pattern that works for the location. Please consider the
following points when routing cables:
• Access to a 3-prong (grounded) power outlet
• Space for the noise filter between the panel and outlet
• Placement of cables under carpets or across walking paths
A reusable cable clamp is designed to lock the bundled cables in place. Your flat panel display has a total of three
holes (60 inches: two holes) to attach cable clamps to the back of the panel. Use the cable clamps as necessary.
1
2
3
4
Ferrite core
Cable tie
To power outlet
AC power cord
As close as possible
Rear
Front
KRP-600M
KRP-500M
Speaker cable
Speaker cable
KRP-600M_500M.book Page 22 Tuesday, May 13, 2008 12:47 PM