Pioneer KRP-500M - Manual (Page 73)

73
En
Use Other Equipment With Your Flat Panel Display 06
Englis
h
6.9 Assign a Serial Number
6.9.1 Assign an ID Number
This section describes how to enter the required ID number for controlling and adjusting multiple panels through
a single PC. To assign the ID Number, follow the directions below.
1 ) Access Serial Setting through the Control Setup menu.
2 ) Select ID No. Set from the Serial Setting menu.
3 ) Select All or 00H-FFH from the submenu.
Note: This setting applies to all input sources.
Parameter Description
00H-FFH sets an ID Number
All does not set an ID Number
C:\> nslookup
Server: xxx.xxx.xxx.com Current name server
Adress: yyy.yyy.yyy.yyy
> mailsv.aaa.com Mail server searched for
Server: xxx.xxx.xxx.com Current name server
Adress: yyy.yyy.yyy.yyy
Non-aurthoritative answer:
Name: mailsv.aaa.com
Adress: zzz.zzz.zzz.zzz Server: IP Address for mailsv.aaa.com
Sample MS-DOS search screen using “nslookup”
IP Control Setting
DHCP : On
IP Control : Disable
IP Address
Subnet Mask
Power On Test
Power Off Test
Power On Ready : Off
Hold Sound Status : Off
Input Setting : Off
Power Off Control : Off
Default Gateway
MAC Address
LED : On
KURO LINK Setting
Serial Setting
ID
No.Set : All
Baud Rate : 9600bps
Exit
Control Setup
ID No.Set All
KRP-600M_500M.book Page 73 Tuesday, May 13, 2008 12:47 PM