Pioneer KRP-500M - Manual (Page 82)

82
En
07 Helpful Information
Sound is wrong (one side
only or reversed between
left and right) • Check if the speaker cable connections have been reversed between the left and right.
• Confirm that speaker cables are connected and seated properly.
• Check the sound balance and adjust if necessary.
Brightness and color
tone on the sides differ
from the center • If images in 4:3 mode or letterbox images are displayed for long periods or for shorter
periods over several days, an after-image may remain due to burning.
Watch images in Full screen as much as possible to avoid this issue.
• Change the Brightness Sync. setting to Auto.
This function adjusts the brightness of the gray side masks for the brightness of the main
image.
• Use the Long Life Settings function (see “4.2.1 Extend Your Panel Life”)
Picture does not appear
properly • Check the setting for Color Decoding when using INPUT 2 or INPUT 3 (pages 56 and 57).
• Check the setting for Signal Type.
• Check the setting for Video when using INPUT 5 through INPUT 6 (page 58).
• Check the setting for Signal Format when using INPUT 5 through INPUT 6 (page 58).
After-image lag • If a bright or still image was on screen for a long period before switching to a darker
image, the original image may appear as an after-image or ghost. Try playing another
bright image, switching the picture quickly many times, or show a very active scene.
• Use the Long Life Settings function (see “4.2.1 Extend Your Panel Life”)
• Display the Video Pattern screen to help reduce after-image lag.
KURO LINK
Issue Possible Solutions
KURO LINK does not
function • Check the connections between the panel and the HDMI equipment.
• Confirm that the settings for the panel are correct.
• Confirm that the equipment is HDMI compliant.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
Error message: “The
device cannot be
operated. Please check
connection”
• Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
No picture and sound • Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
No picture • Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
No sound • Check the connections between the panel and the HDMI equipment.
• Confirm that settings for the equipment are correct.
For details, refer to the operating instructions that came with the equipment.
• Check that the AV system is connected to an HDMI terminal and any recorder/player is
connected to another HDMI terminal.
Panel sounds/noises • Some sounds are appropriate for plasma technology.
Examples: fan motor noise, electrical circuit humming, glass panel buzzing, etc.
Picture/Sound
Issue Possible Solutions
KRP-600M_500M.book Page 82 Tuesday, May 13, 2008 12:47 PM