Pioneer KRP-500M - Manual (Page 76)

76
En
06 Use Other Equipment With Your Flat Panel Display
Monotone Mode
Monotone Mode cuts the video signal’s color components so that images appear using only luminance signals.
Notes: This setting applies to all input sources.
Entering Studio Mode, AV Selection or Picture Preset is unavailable while in Monotone Mode.
Drive Mode
This option optimizes the picture quality depending on the content (refer to “5.3.10 Adjust Color Signals” for more
information).
Note: Drive Mode is available only for input video signals.
FRC Mode
The FRC option allows switching the frame rate conversion.
Note: FRC Mode is available only for input PC signals.
Fan Control
This option switches the control method for the rear cooling fan of the flat panel display.
The Max setting is effective for special high-temperature installations. However, since the fan noise increases, the
effect on the surrounding area should be taken into consideration.
Parameter Description
On switches to the Monotone Mode
Off* No effect
*Factory default
Parameter Description
Default* does not switch the frame rate conversion
Sync switches the frame rate conversion
*Factory default
Parameter Description
Auto* automatically controls using an internal
temperature sensor
Max for maximum rpm (Auto Control: Off)
*Factory default
KRP-600M_500M.book Page 76 Tuesday, May 13, 2008 12:47 PM