Pioneer CU-RF100-U - Manual (Page 12)

Controlling the rest of your system 03
12
En
Chapter 3:
Controlling the rest of your
system
About the Remote Setup menu
The Remote Setup mode is set by pressing the
HOME MENU button while pressing MULTI
OPERATION. The different items on the
Remote Setup menu are described below. For
their setting procedures, refer to the
explanations for the respective items.
Setting What it does
PRESET
RECALL Preset codes can be set for the various
input functions. The remote control
codes of a number of other devices
(including products of other brands) are
preset in the remote control to allow
these devices to be operated. See
Selecting preset codes directly on page 14.
CODE
LEARNING If the desired operations cannot be
performed even though you have set the
preset codes, the remote control signals
of other devices can be learned directly.
See Programming signals from other
remote controls on page 14.
MULTI
OPERATE A series of the remote control operations
for starting listening or viewing can be
programmed. Multiple remote control
codes can be set for the different input
functions. See Multi Operation and
System Off on page 17.
SYSTEM
OFF This is a function for automatically
turning off the power of devices
connected to the receiver. Multiple
remote control codes can be set, as
desired. See Multi Operation and System
Off on page 17.
DIRECT
FUNC This is a setting for changing only the
remote control unit’s operation screen,
without changing the receiver’s input,
when the remote control unit’s input
function buttons are pressed. This is
convenient for using the remote control
unit for devices not connected to the
receiver. See Direct function on page 17.
RENAME The names of the input function buttons
displayed on the remote control unit can
be changed as desired. See Renaming
input function names manually on
page 17.
SYNC
RENAMING Input function names changed on the
receiver can be acquired by the remote
control unit so that the names are the
same on the remote control unit. See
Renaming input function names in
synchrony with the receiver on page 8.
ERASE
LEARNING This function is used to erase remote
control codes that have been learned.
Codes learned for the different input
functions can be erased individually. See
Erasing one of the remote control button
settings on page 16.
IR/RF
SELECT This function is for selecting wireless (RF)
or infrared (IR) as the remote control
operating mode for the different devices.
See Operating the receiver by RF
communications on page 7 and
Operating other components by RF
communications on page 7.
OPERATION
MODE The remote control unit’s operation
screen switches automatically when the
receiver’s input is switched (This is only
valid when the operation selector switch
is set to
SOURCE). See Setting the remote
control operation mode on page 9.
KEY RESET This is a function for resetting preset
codes that have been set. Key resetting
can be done for individual input
functions. See Resetting the input
assignment of one of the input function
buttons on page 16.
ALL RESET This is a function for resetting all remote
control unit settings you have made to
the defaults set upon shipment from the
factory. See Resetting the remote control
settings on page 16.
Setting What it does
CU-RF100.book Page 12 Wednesday, March 17, 2010 6:13 PM