Erasing one of the remote control button settings, 1 while pressing multi operation, press home menu, 5 repeat step 4 to erase other buttons – Pioneer CU-RF100-U User Manual
Page 16: 2 use i/j to select ‘key reset’, then press enter, Resetting the remote control settings, 2 use i/j to select ‘all reset’, then press enter, 3 press and hold enter for about two seconds, Confirming preset codes, Controlling the rest of your system 03
Controlling the rest of your system
03
16
En
Erasing one of the remote
control button settings
This erases one of the buttons you have
programmed and restores the button to the
factory default.
1
While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
2
Use
/ to select ‘ERASE LEARNING’,
then press ENTER.
The remote display prompts you for the
component corresponding to the button
setting to be erased.
3
Press the input function button
corresponding to the command to be erased,
then press ENTER.
The remote display flashes
PRESS KEY.
4
Press and hold the button to be erased for
two seconds.
The remote display shows
OK or NO CODE to
confirm the button has been erased.
5
Repeat step 4 to erase other buttons.
6
Press and hold MULTI OPERATION for a
couple of seconds when you’re done.
Resetting the input assignment
of one of the input function
buttons
This procedure resets the input assignment
preset at the remote control’s input function
button, restoring the default.
1
While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
2
Use
/ to select ‘KEY RESET’, then
press ENTER.
The remote display prompts you for the
component corresponding to the button
setting to be erased.
3
Press the input function button for the
component whose input assignment you
want to reset, then press and hold ENTER for
a couple of seconds.
The remote display shows
OK when the input
assignment of the remote control’s input
function button is reset.
Resetting the remote control
settings
Use this procedure to reset all the remote
control’s settings to the factory default.
1
1
While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
2
Use
/ to select ‘ALL RESET’, then press
ENTER.
ALL RESET flashes in the remote display.
3
Press and hold ENTER for about two
seconds.
The remote display shows
OK to confirm the
remote presets have been erased.
Confirming preset codes
Use this feature to check which preset code is
assigned to an input function button.
1
While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
2
Use
/ to select ‘READ PRESET ID‘,
then press ENTER.
The remote display prompts you for the input
function button you want to check.
Note
1 When Selecting preset codes directly on page 14 are set, all the signals learned in the input function buttons are
cleared. This function is convenient when you want to reset some but not all of input function buttons.
CU-RF100.book Page 16 Wednesday, March 17, 2010 6:13 PM