Pioneer CU-RF100-U - Manual (Page 8)

Using the RF communications function 02
8
En
1 Connect the IR blaster to the RF Adapter’s
IR Blaster terminal and mount the transmitter
on the component you want to operate with
RF communications.
• Operation is not possible unless the IR
blaster is mounted in an appropriate
position. Whenever possible, mount it
above the other component’s remote
control sensor. If mounted below, the
influence of external light, etc., could
hamper reception.
• Mount the IR blaster securely to a position
near the other component’s remote control
sensor. For the location of the other
component’s remote control sensor, see
the component’s operating instructions.
• Clean any dirt or dust off the place at which
the double-faced tape is to be attached
beforehand.
• Note that the double-faced tape is strong,
and that trying to peel it off the shelf, etc.,
after it has been applied may damage the
shelf’s surface.
2 While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
3 Use
/ to select ‘IR/RF SELECT’, then
press ENTER.
Check that the units are paired. If
RECEIVER
MAIN is displayed, pairing has been
performed properly, so proceed to step 4. If
RF
MODE ONLY flashes, pairing has not been
performed properly, so perform this procedure
again after performing pairing (see Pairing the
RF adapter and remote control on page 6).
4 Use
/ to select input function for the
component you want to operate using RF
communications, then press ENTER.
Select the input component to which the IR
blaster was mounted in step 1.
5 Use / to select ‘RF MODE’, then press
ENTER.
Select
IR MODE to return to operation by
infrared signal.
6 If other input function buttons also
switch to RF communications operation,
repeat step 4 to 5.
7 Press and hold MULTI OPERATION for a
couple of seconds to exit and store the
operation(s).
Renaming input function names
in synchrony with the receiver
• Default setting: MANUAL
The remote control input display names can be
synchronized with the input names that have
been changed at
Input Name on the receiver’s
Input Setup menu (see receiver’s operating
instructions) and acquired automatically.
There are two modes:
AUTO in which the
receiver’s input names are acquired
automatically each time the input is switched,
and
MANUAL in which the receiver’s input
names are only acquired for input functions
selected manually. Even when input names are
changed manually at Renaming input function
names manually on page 17, when synchro
renaming is performed here, the input name is
overwritten.
1 While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
RF adapter
CU-RF100.book Page 8 Wednesday, March 17, 2010 6:13 PM