Pioneer CU-RF100-U - Manual (Page 6)

Using the RF communications function 02
6
En
• RF communications can be used to
operate up to 4 other components
connected to the receiver (using the
included IR blaster. For details, see
Operating other components by RF
communications on page 7).
• The remote control input display names
can be synchronized with the input names
changed at
Input Name on the receiver’s
Input Setup menu (see receiver’s
Operating Instructions) and acquired
automatically. For details, see Renaming
input function names in synchrony with the
receiver on page 8.
• When the receiver’s input is switched, the
remote control’s display and operating
mode switch to that input automatically.
For details, see Setting the remote control
operation mode on page 9.
Important
• The line-of-sight communications distance
is a rough indication, and may differ
according to the surrounding environment.
• Depending on the communications
environment, functions using two-way
communications between the receiver and
remote control may not operate properly.
For details, including cautions on the
communications environment and usage
procedure, etc., see Precautions when
using the Omni-Directional RF Remote
Control on page 10.
Note
• You can cancel or exit any of the steps by
press and hold MULTI OPERATION for a
couple of seconds. To go back a step, press
RETURN.
Pairing the RF adapter and
remote control
Pairing is necessary in order to use the RF
communications function. Perform the
operation below after connecting the RF
adapter and receiver.
1 Switch on the receiver.
2 Setting the ‘RF Remote Setup’ or
‘EXTENSION Setup’ to ‘ON’ for the receiver’s
‘Other Setup’.
For details, see receiver’s operating
instructions.
3 Press the SETTING button on the front of
the RF adapter.
RF adapter’s LED blinks red.
4 While pressing MULTI OPERATION, press
VIDEO PARAMETER on the remote control.
The remote display shows
PAIRING.
5 Press ENTER on the remote control.
AUTHORIZATION flashes and pairing is
performed. When pairing is successful,
SUCCESS is displayed and pairing is
completed. RF adapter’s LED lights green.
The display on the receiver itself is displayed on
the remote control’s display. For details, see
Remote control display on page 24.
If ERROR is displayed, pairing has not been
successful. Check the connections and
distance with the RF adapter, then start over
from step 1.
The remote control unit’s receiver operation
mode must be set to “RF” in order to operate
the receiver with RF two-way communications.
Make this setting as described at Operating the
receiver by RF communications on page 7.
CU-RF100.book Page 6 Wednesday, March 17, 2010 6:13 PM