Pioneer CU-RF100-U - Manual (Page 9)

Using the RF communications function 02
9
En
English 2 Use / to select ‘SYNC RENAMING’,
then press ENTER.
MANUAL flashes in the remote display. 1
3 Use / to select ‘AUTO’ or ‘MANUAL’,
then press ENTER.
If you selected
AUTO, this completes the
setting. The receiver’s input names are
acquired automatically in synchrony with the
receiver each time the remote control’s input is
switched. Proceed to step 7.
If you selected MANUAL, go to step 4.
4 Press the input function button for the
component whose receiver input name you
want to acquire, then press ENTER.
2
The receiver’s input name is acquired. After
PLEASE WAIT is displayed, the receiver’s input
name flashes. If the name has not been
changed at
Input Name on the receiver’s
Input Setup menu (see receiver’s operating
instructions),
NO CHANGE flashes.
5 Press ENTER to enter the input name
displayed on the remote control.
COMPLETE is displayed and the input name is
registered.
6 To acquire the receiver input names for
other input function buttons, repeat step 4 to
5.
7 Press and hold MULTI OPERATION for a
couple of seconds to exit and store the
operation(s).
Setting the remote control
operation mode
• Default setting: ON
When the remote control operation mode is
turned on and the receiver’s input is switched,
the remote control display and operation mode
switch automatically to that input. Select
OFF if
you do not want the remote control’s function
to switch automatically when the receiver’s
input is switched.
3
1 While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
2 Use
/ to select ‘OPERATION MODE’,
then press ENTER.
Check that the units are paired. If
SYNCHRO
ON is displayed, pairing has been performed
properly, so proceed to step 3. If
RF MODE
ONLY flashes, pairing has not been performed
properly, so perform this procedure again after
performing pairing (see Pairing the RF adapter
and remote control on page 6).
3 Use / to select ‘SYNCHRO ON’ or
‘SYNCHRO OFF’, then press ENTER.
The remote display shows
OK to confirm the
setting.
4 Press and hold MULTI OPERATION for a
couple of seconds to exit and store the
operation(s).
Note
1 If RF MODE ONLY flashes, pairing has not been performed properly or RECEIVER may be set to IR MODE at the
remote control’s IR/RF SELECT setting. In this case, perform pairing, then switch RECEIVER to RF MODE at the
remote control’s IR/RF SELECT setting. For details, see Pairing the RF adapter and remote control on page 6 and
Operating the receiver by RF communications on page 7.
2 The HDMI input function button is not supported.
3 • When the remote control’s input is switched, the receiver’s input also switches, but for functions for which the
remote control direct function (page 17) is set to off, when the remote control’s input is switched, the receiver’s input
does not switch and only the remote control unit’s operating screen switches.
• The remote control operation mode is only valid when the remote control operation selector switch is set to
SOURCE.
CU-RF100.book Page 9 Wednesday, March 17, 2010 6:13 PM