Pioneer AVH-P6400CD - Manual (Page 61)

En 61
English
Espa
ñ
ol
Deutsch
F
ran
ç
ais
Italiano
Nederlands
12
Section
Audio Adjustments
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press
5 or ∞ to select
LOUDNESS from the
AUDIO MENU, and press A.MENU .
LOUDNESS adjustment indications are dis-
played.
2 Press
5 to turn loudness on.
Loudness level (e.g., LOUDNESS:ON/
MODE:MID ) appears in the display.
3 Press
2 or 3 to select the level.
Press
2 or 3 until the desired level appears in
the display.
LOW (low)— MID (mid)— HIGH (high)
4 Press
∞ to turn loudness off.
LOUDNESS:OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press
5 or ∞ to select
SUB WOOFER from
the AUDIO MENU, and press A.MENU .
SUB WOOFER adjustment indications are dis-
played. When the subwoofer controller setting
is
S.W CTRL:EXTERNAL , you cannot select SUB
WOOFER .
2 Press
3 to turn subwoofer output on.
SUB WOOFER:ON appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
2. If you do not set to ON, you cannot select
PHASE, LEVEL or FREQUENCY .
3 Press
5 or ∞ to select the item you want to
adjust.
4 Press
2 or 3 to adjust the item.
PHASE (phase)
NORMAL (normal)— REVERSE (reverse)
LEVEL (adjustment level)
• +6 – –6 is displayed as the adjustment level is
increased or decreased.
FREQUENCY (cut-off frequency)
50 — 125 (Hz)
• Only frequencies lower than those in the
selected range are output from the subwoofer.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit’s
low pass filter (for the subwoofer), but is output
through the RCA output.
When the non fading output is on, you can
adjust the level of non fading output.
1 Press
5 or ∞ to select
NON FADING from
the AUDIO MENU, and press A.MENU .
NON FADING adjustment indications are dis-
played. When the subwoofer controller setting
is
S.W CTRL:EXTERNAL , you can select non
fading output on/off mode.
2 Press
5 to turn non fading output on.
NON FADING:ON appears in the display. non
fading output is now on.
• You can turn off non fading output by pressing
∞.
3 Press
2 or 3 to adjust the output level of
the non fading.
Each press of
2 or 3 increases or decreases
the level of the non fading (e.g., +6 to –6 ).
Press
2 or 3 until you see the desired value
displayed.