Pioneer AVIC-F10BT - Manual (Page 120)

The term
“external unit” refers to future
Pioneer devices that are not currently planned
for, or to devices that allow control of basic
functions although they are not fully con-
trolled by the navigation system. Two external
units can be controlled by this navigation sys-
tem. When two external units are connected,
the navigation system allocates them as exter-
nal unit 1 or external unit 2.
For details of the connection method, refer to
“Installation Manual”.
For details concerning operation, refer to the
external unit
’s operation manual. This section
provides information on external unit opera-
tions with the navigation system that differ
from those described in the external unit
’s op-
eration manual.
p Operation varies depending on the external
unit connected. (In some cases, the exter-
nal unit may not respond.)
Reading the screen
1 2 5 6 4 3
1 Source icon
Shows which source has been selected.
2 External unit indicator
Displays the information that is sent by con-
nected external units.
3 TRFC indicator
Shows the status of traffic announcements.
4 NEWS indicator
Shows the status of news programmes.
5 Auto/Manual mode indicator
Shows the current mode.
6 Current time
Using the touch panel keys
% Touch [EXT1] or [EXT2] on the “AV
Source
” menu to select the external unit.
= For details concerning operations, refer to
Screen switching overview on page 18.
1
2
5 4
3
1 Send a band command
Touch to send a band command to the ex-
ternal unit.
p Operation varies depending on the exter-
nal unit connected. (In some cases, the
external unit may not respond.)
2 Send an [a], [b], [c], or [d] command
Touch to operate the external unit.
p Operation varies depending on the exter-
nal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
3 Switching between automatic and man-
ual function
You can turn automatic and manual func-
tion on or off.
You can switch between
Auto and Manual
functions of the external unit connected.
Initially, this function is set to
Auto.
p Operating commands set for Auto and
Manual operations vary depending on
the external unit connected.
4 Send a 1 key to 6 key command
The external unit can be operated by trans-
mitting the operating commands set to
1
key
— 6 key.
p Operation varies depending on the exter-
nal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
5 Use F1 — F4 to operate the external unit
Using the external unit (EXT1, EXT2)
Engb
120
Chapter
26