Pioneer DV-668AV-S - Manual (Page 14)

Connecting up 02
14
En
Easy connections
The setup described here is a basic setup that
allows you to play discs using just the cables
supplied with the player. In this setup, stereo
audio is played through your TV.
• This player is equipped with copy
protection technology. Do not connect
this player to your TV via a VCR using AV
cables, as the picture from this player will
not appear properly on your TV. (This
player may also not be compatible with
some combination TV/VCRs for the same
reason; refer to the manufacturer for
more information.)
1 Connect the VIDEO OUT and AUDIO
OUT (2ch) jacks to a set of A/V inputs on
your TV.
Use the supplied red/white stereo audio and
yellow video cable. Make sure you match up
the left and right audio outputs with their
corresponding inputs for correct stereo
sound.
See Using other types of video output below if
you want to use a different type of connection.
• If you need another pair of stereo outputs
(and don’t need to use the multichannel
analog outputs), you can use the
AUDIO
OUT (5.1ch) FRONT L / R jacks (page 16).
2 Connect the supplied AC power cord
to the AC IN inlet, then plug into a power
outlet.
• Do not unplug the player from the power
outlet while it is switched on.
• Do not plug this player into a switched
power supply found on some amplifiers
and AV receivers.
AUDIO
OUT
(2ch)
AUDIO
OUT
(5.1ch)
CONTROL
OPTICAL
COAXIAL
IN OUT
R
L L
R
CENTER
SUB
WOOFER
SURROUND FRONT
S-VIDEO
OUT
VIDEO
OUT COMPONENT VID
P B P R Y 2 1 2 1
(AUDIO)
S400
AC IN
DIGITAL AUDIO
OUT
HDMI OUT
AV CONNECTOR 1 (RGB)-TV/AV Receiver
To power outlet
TV
A/V IN
868en.book.fm 14 ページ ２００３年８月１９日 火曜日 午前９時３０分