Pioneer PDP-4280XA - Manual (Page 16)

Preparation 05
16
En
Attaching/detaching the Pioneer stand
(for PDP-4280XA only)
Caution
• The weight of a 42 inch plasma television is about 29.5 kg (65.0
lbs.), it has little depth, and is unstable. Therefore, at least two
people must assemble and install it.
Detaching the stand
When you use a stand, brackets and other fittings than the attached,
use the following procedure to remove the attached stand.
1 With the plasma television lying flat, loosen and remove
the installation bolts (1) and (2) using a screwdriver.
2 Remove the stand from the plasma television.
• Make sure to keep the installation bolts (1) and (2) that have
been removed as they are reused when attaching the stand to
the plasma television.
Note
• Be sure to install the plasma television in a flat, stable location.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma television lying flat on a table or
similar surface.
• When lying the plasma television down, be careful not to
scratch or damage it.
Reattaching the stand.
1 With the plasma television lying flat, fit the stand’s
support columns to the bottom of the plasma television as
indicated by the arrows, then slowly insert them.
• Be extremely careful not to insert the support columns of the
stand into any part of the plasma television other than the stand
insertion slots. Doing so might damage the plasma television
panel or its ports or result in warping of the stand.
2 Attach the stand at the points indicated by the arrows and
tighten the installation bolts (2) and (1) firmly using a
screwdriver.
Note
• Be sure to install the plasma television in a flat, stable location.
• Insert the screws into the holes vertically and tighten them.
• Place a sheet or protective cover to protect the display from
scratches or damage.
• Work only with the plasma television lying flat on a table or
similar surface.
• When lying the plasma television down, be careful not to
scratch or damage it.
Installation bolts (1)
(M8 x 23 mm: black)
(Step 2)
Installation bolts (2)
(M8 x 60 mm: black)
(Step 1)
Plasma
television
Sheet
Plasma
television
Sheet
Insert the stand into
the plasma television
so that an arrow with
“FRONT/FACE AVANT”
mark inscribed at the
bottom of the stand
indicates downward.
Line up the column supports
with the bottom of the
plasma television, as
indicated in the
accompanying
diagram.
Installation bolts (1)
(M8 x 23 mm: black)
(Step 2)
Screw hole with “T” inscribed
Installation bolts (2)
(M8 x 60 mm: black)
(Step 1)
PDP-5080XA_En.book Page 16 Monday, May 14, 2007 11:33 AM