Pioneer PDP-4280XA - Manual (Page 40)

Useful adjustment settings 09
40
En
Changing the password
Use the following procedure to change the password.
1 Press HOME MENU.
2 Select “Setup“ ( / then ENTER).
3 Select “Password“ ( / then ENTER).
The password entry screen appears. Enter the current four-digit
password using buttons
0 to 9.
4 Select “Change Password“ ( / then ENTER).
5 Enter a four-digit password to be newly set, using buttons 0
to 9.
6 Enter the same password that you have entered in step 5.
• If a different password is entered, the operation goes back to
step 5 for reentry from the beginning.
• You can try up to three times to reconfirm the new password
before the Change Password screen is automatically exited.
7 Press HOME MENU to exit the menu.
Note
• Take a note of the newly set password and keep it handy.
Resetting the password function
1 Press HOME MENU.
2 Select “Setup“ ( / then ENTER).
3 Select “Password“ ( / then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons
0 to 9.
4 Select “Reset“ ( / then ENTER).
5 Select “Yes“ ( / then ENTER).
6 Press HOME MENU to exit the menu.
Note
• The above procedure will reset the password to the factory
default (1 2 3 4).
Disabling the password function
Use the following procedure if you want to deactivate the protection
function that prompts password entry. The factory default is
“Enable”.
1 Press HOME MENU.
2 Select “Setup“ ( / then ENTER).
3 Select “Password“ ( / then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons
0 to 9.
4 Select “Password Setting“ ( / then ENTER).
5 Select “Disable“ ( / then ENTER).
6 Press HOME MENU to exit the menu.
Note
• The above procedure will reset the password to the factory
default (1 2 3 4).
• After disabling the password function, you cannot change the
Child Lock settings. See Setting Child Lock on page 25.
• After disabling the password function, you cannot change or
reset the password.
• When you enable the password function again after disabling it,
the factory default password (1 2 3 4) is restored.
Change Password
Please Input New Password.
Reconfirm New Password.
We suggest you write down your password so you don’t forget it.
If you forget the password
When the message “Please Input Your Password.” is displayed,
press the
ENTER button on the remote control unit and hold it
down for three seconds or longer.
The password reverts to “1234”.
PDP-5080XA/PDP-4280XA
Your password No.:
PDP-5080XA_En.book Page 40 Monday, May 14, 2007 11:33 AM